Dimensions and capacities

The interior cargo area measures 1,140 mm (45 in) high, with a load length of 1,700 mm (67 in) and width of 1,190 mm (47 in) between the wheelhousings. Liftover height is 570 mm (22 in) from the ground.^[3]: 102 The gross vehicle weight rating is 1,966 kg (4,334 lb), providing a maximum payload of 500 kg (1,100 lb), including the weight of the driver.^[3]: 100

Powertrain

The electric traction motor develops its maximum torque of 180 N⋅m (130 lbf⋅ft) between 0 and 1600 RPM; maximum power is 28 kW (38 hp), delivered between 1600 and 5500 RPM. The continuous power rating is 15.5 kW (20.8 hp); the motor operates at a nominal 400 V.^[4] It is a brushed DC electric motor ("continuous current with separate excitation")^[3]: 100 which requires periodic maintenance to replace the carbon brushes.

The high-voltage storage battery uses 27 nickel-cadmium modules, each operating at 6 V and with a capacity of 100 A-hr, giving the total series-connected assembly a nominal voltage of 162 V and a storage capacity of 16.2 kW-hr.^[4] Average consumption is 26 kWh/100 km (81 mpg‑e).^[3]: 100

The Berlingo électrique is equipped with direct drive transmission; the electric motor turns the wheels directly through a reduction gear set. The vehicle is often mistakenly described as having an "automatic" gearbox whereas in reality the very wide power range of the electric motor when compared with the very narrow power band of an Internal Combustion Engine means that more than one gear is unnecessary. The Berlingo électrique has in effect only one forward gear which serves from 0-70 mph (110 km/h). The driving mode selector looks similar to an automatic gearbox selector but is limited to Drive, Neutral, Reverse and Park.^[3]: 43

Speed and range

Numerous factors affect energy consumption, including terrain, weather, vehicle speed, and controller efficiency. The actual maximum range will depend on the driving style, especially the speed. This is because atmospheric drag is non-linear with speed, i.e., increasing the speed by 25% will decrease the range by 36%. To get the most range for any electric vehicle (and to some extent petrol/diesel vehicles) involves driving at the slowest practical speed. For example, with the Berlingo, energy consumption when driven gently at a slow speed of 35 mph (56 km/h) can be 250 Wh/mi (130 mpg‑e), but consumption can increase to 600 Wh/mi (56 mpg‑e) if driven faster. When driven faster than 50 mph (80 km/h), the Berlingo électrique controller starts to heat up and becomes less efficient.^[5]

Typical ranges are as follows.

As with any vehicle, driving in rain and snow increases rolling resistance and therefore decreases the miles-per-gallon for petrol/diesel and reduces the miles-per-charge for electric vehicles. Typical reduction in efficiency is about 15%.^[6]

Starting

The ignition key controls the expected functions as a conventionally-powered car; turning the key clockwise through its detents enable accessories at the first stop, then the ignition circuit at the second stop; beyond the second stop, the starting circuit is engaged.^[3]: 44

The function of the ignition position (second detent) is slightly different from regular cars as only the STOP and handbrake warning lights (if the handbrake is applied) are displayed.^[3]: 44 In the conventional Berlingo all the indicator lights are shown at the ignition position to check bulb condition.

When the ignition key is moved to the start position, which is spring-loaded and returns to the second (ignition) detent, the main traction battery relay is energised, causing an audible clunk, and the traction battery is connected to the motor. The STOP warning light is extinguished, and after either the Drive or Reverse position is selected, the accelerator can be used to move the vehicle as normal. If the traction battery plug is connected, the STOP warning light flashes and the vehicle is unable to start. Similarly, if the accelerator is being pressed, or the vehicle is not stationary, the vehicle is unable to start.^[3]: 44

When the Drive position is selected, the green forward gear warning lamp in the instrument panel will illuminate. When the Reverse position is selected, the orange reverse gear warning lamp will illuminate.^[3]: 45

Instrumentation

The instrument panel features two large round analog gauges, with an analog arc-shaped "Téconoscope"/"Econoscope" between them. The left-hand gauge is a conventional speedometer, while the right-hand gauge provides state of charge information. The Téconoscope provides instantaneous energy flow information; the needle goes to the center ("0") when the vehicle is at rest, moving to the left ("ECO") when energy is being returned to the battery, and to the right (in green, orange, or red zones) to indicate the rate of charge depletion.^[4] There is a warning lamp at the far left position of the Téconoscope, which lights when vehicle performance has been limited, either due to low state of charge or when temperature limits have been reached.^[3]: 46

The large energy meter display shows remaining energy as a percentage and is surprisingly accurate. The good accuracy is provided by the onboard controller monitoring the Amp-hours in and out of the battery rather than the battery voltage. Besides the Téconoscope limited-performance warning light, there is a "traction battery discharged" warning lamp which is designed to illuminate when the state of charge falls below 20%;^[3]: 46 however, it is operated by the battery voltage. This can mean that the low energy light does not always illuminate at exactly the same percentage charge across different vehicles or even the same vehicle at different times.

Rectangular warning lights at the bottom of the instrument panel are grouped in three clusters within a single row and include:^{[3]: 32–33}

Name (color)	Door-open warning (red)	Rear foglamp (amber)	Dipped beam (green)	Main beam (blue)
Purpose	Illuminates when key is in ignition position; extinguishes when doors are closed properly.	Rear warning light is illuminated	Headlights are in dipped position (normal driving)	Headlights are in main position (extra illumination, but may dazzle other drivers)
Name (color)	Traction battery charge (green)	Traction battery discharged (amber)	Low heater fuel level (amber)	Auxiliary battery charge failure (red)	STOP (red)
Purpose	Flashes when charging	Illuminates when Power Gauge shows state of charge ≤ 20%	Illuminates when ≤ 2 L (0.44 imp gal; 0.53 US gal) of fuel remain	Indicates a fault in the 12 V battery for accessories and vehicle electronics	Illuminates when switched to ignition position to indicate traction motor and battery are not connected; extinguished when traction battery relay closes. Flashes to indicate charging plug still connected.
Name (color)		Electrical fault (amber)	Handbrake and low brake fluid level (red)	Low traction battery water level (amber)
Purpose		Indicates a fault has been detected by the engine control unit; dealer service recommended	Illuminates when handbrake is on, brake fluid level is low, or a fault has been detected in the regenerative braking system	Indicates battery water level is low

Heating

In order to minimise battery usage, a petrol driven heater is fully integrated to vehicle. It typically takes 5 to 10 minutes to warm and provides excellent cabin heating. It takes several minutes for the heater to run down and will therefore continue to operate after the ignition is turned off.

The heater fuel tank has a capacity of 8 L (1.8 imp gal; 2.1 US gal). Typical fuel consumption rate is 0.5 L/h (0.11 imp gal/h; 0.13 gal/h).^[3]: 58

Brakes

When the accelerator is released, regenerative braking returns kinetic energy to the traction battery.^[3]: 55

Power assisted brakes are supplied as standard. However, because the vacuum supply from the engine inlet manifold that normally supplies the brake servo is not available on an electric vehicle, a dedicated vacuum pump is used. Typical operation of the vacuum pump is on for 10–15 seconds and off for a couple of minutes. When the ignition is switched off, braking is not power-assisted.^[3]: 55

When the very powerful regenerative braking is active the brake lights are not illuminated. This can be disconcerting for other drivers who may not notice the van slowing significant without the help of the brake lights. The manual states that with a full blown PSA service terminal, brake light operation during regenerative braking can be set to "on" though, while it is set to "off" by default.

Power steering

Power steering is supplied as standard. However, because the continuous rotation of the engine is not available on an electric vehicle, an electric motor is used to power a power steering hydraulic pump.

Charging

Charging may be performed using a domestic power connector, using a cord stored underneath the passenger's seat. In the UK, the domestic power supply socket should supply 230 V and 16 A, be earthed, and differential current protected (30 mA).^[3]: 48 With a 230 V/16 A supply, it takes approximately seven to eight hours to replenish the traction battery to 100% when starting from 20% with a domestic connection.^[3]: 47

Rapid charging is possible using an Avcon connector to the vehicle inlet on the front wing. The vehicle inlet door acts as a switch, so charging does not start until the switch is closed; there is a small flap to accommodate the connector handle.^{[3]: 48–50} Rapid charging stops when the traction battery has reached 80% state of charge. If the state of charge is 80% or greater, rapid charging is not possible. With a 150 A supply, the vehicle replenishes approximately 20% state of charge every eight minutes with rapid charging.^[3]: 51

The manual does not indicate that removing the charging plug before it is fully charged can illuminate the 'Electrical Fault Light' which stays on until a full trickle charge is performed. This can be quite disconcerting as the manual states the car has to be taken to the dealer to reset the problem. Also, one cannot, or should not, perform a fast charge when it is in this state.

Service items

The Electrique is a simple vehicle with minimal servicing requirements. Under the front bonnet, the auxiliary/accessory battery can be accessed, along with the fusebox and several vehicle fluids (windshield washer, power steering, coolant, and brake).^[3]: 66 Servicing information is available at Citroën Berlingo Electrique Service Manual

Synthetic hydraulic brake fluid should be changed every two years or 60,000 km (37,000 mi), whichever is sooner.^[3]: 81

Original equipment tyres are sized 165/70 R14, and should be inflated to 41 psi (2.8 bar).^[3]: 95

Battery watering must be done at regular intervals (approximately every 4,000 miles (6,400 km), depending on usage) and this can be done either at a dealership or by using a kit provided by a third party.

Brush replacement should also be done according to the maintenance schedule, as serious damage will result if it is overlooked.

Common DIY enhancements

The basic Electrique does not come with rear seats or windows. It is common for owners to install a compatible rear seat and rear windows from a conventional Berlingo I Multispace, in countries where this is allowed (not in France).

Enthusiast websites

• "Berlingo-e information". berlingo-e.co.uk., no longer updated as of August 2016
• "Citroën Berlingo Electrique". Citroënët. Archived from the original on August 4, 2007.
• "About the Citroen Berlingo Electrique". drivelectric: the electric vehicle specialists. Archived from the original on May 18, 2006.
• "Battery Vehicle Society (UK)"., includes a register of Berlingo Electriques and a forum with useful information for all users.
• "Citroen Berlingo Electrique". Electric Driver. Archived from the original on September 27, 2010.
• Clean Vehicles with Electric Drive Final report from the Swedish research, development and demonstration programme on electric and hybrid vehicles 1993-2000