Phone Line Interface IC IXYS Litelink CPC5621A

The term data access arrangement (DAA) has the following meanings:

  1. In public switched telephone networks, a single item or group of items at the customer side of the network interface device for data transmission purposes, including all equipment that may affect the characteristics of the interface.
  2. A data circuit-terminating equipment (DCE) supplied or approved by a common carrier that permits a DCE or data terminal equipment (DTE) to be attached to the common carrier network.

Data access arrangements are an integral part of all modems built for the public telephone network. In view of mixed voice and data access, DAAs are more generally referred to as direct access arrangements.

Requirement for DAAs

While DAA now describes an integral component of a device that connects to the telephone network, during the 60s and 70s it described a separate device mandated by the Bell System, connected between the telephone line and non-Bell equipment, typically a modem.

Following the Carterfone decision, which required Bell to allow customers to attach any non-harmful equipment to their network, Bell mandated that subscribers use PCAs/DAAs - purchased exclusively from Western Electric - to ensure the network was protected. These devices were not required for Bell-provided equipment, only equipment made by independent manufacturers.[1][2]

At the time, some subscribers believed that the DAA was a scheme by AT&T to penalize and discourage use of non-Bell modems and recover lost profits from hardware sales,[3] and the FCC began investigations into the legality of the practice.[1] Subscribers also became frustrated when Bell failed to deliver DAAs in a timely fashion after the ruling, leading to the use of unauthorized third-party DAAs.[4]

There were two main varieties of DAA described by AT&T: manual and automatic. A manual DAA required a call to be initiated (or answered) as normal, at which point it could then be connected to the third-party device, while an automatic DAA allowed an attached device to be connected without human intervention, important for receiving modem use.[4]

In 1975, the FCC implemented Part 68 of the FCC Rules,[5] which granted permission for direct connection of any equipment to the telephone network given compliance with specific electrical requirements. This technically eliminated the need for DAAs,[2] although the first modem that didn't require a separate DAA was not marketed until 1977 when a court ruled that Part 68 was legal.[6]

References

  1. 1 2 "Computerworld". Internet Archive. 1972-01-09. Retrieved 2020-08-13.
  2. 1 2 Enterprise, I. D. G. (1975-11-12). Computerworld. IDG Enterprise.
  3. ↑ "Computerworld". Internet Archive. 1972-07-19. Retrieved 2020-08-13.
  4. 1 2 "Computerworld". Internet Archive. 1969-09-24. Retrieved 2020-08-13.
  5. ↑ 2000 Biennial Regulatory Review of Part 68 of the Commission's Rules and Regulations (PDF). FCC. p. 51. Archived (PDF) from the original on 2022-10-09. [...]in 1975 when the Part 68 program was originally implemented
  6. ↑ Enterprise, I. D. G. (1977-06-13). Computerworld. IDG Enterprise.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.