New York and Canada Railroad

Overview
Founders	Isaac V. Baker Smith Mead Weed
Predecessors	Montreal and Plattsburgh Railroad New York and Canada Railroad Whitehall and Plattsburgh Railroad
Successor	Delaware and Hudson Railway
Technical
Track gauge	1,435 mm (4 ft 8+1⁄2 in)
Route map mi Lacolle Subdivision M&NY Rouses Point Subdivision Quebec New York Rouses Point Junction O&LC Mooers Junction 21 191 Rouses Point 187 Cooperville Sciota 15 184 Chazy Chazy Junction 177 West Chazy 172 Beekmantown 168 0 Plattsburgh 6 Salmon River 9 Lapham's 11 Peru 15 Harkness 18 Ferrona 23 Ausable Forks 155 Port Kent 143 Willsborough 138 Essex 134 Whallonsburg 131 Wadahm's Mills 128 Westport 117 Port Henry 110 Crown Point 102 Addison Junction Addison Railroad 5 Baldwin 2 Ticonderoga Ticonderoga Junction 0 100 Fort Ticonderoga 98 Wrights 93 Putnam 88 Dresden 85 Clemons 78 Whitehall R&S to Saratoga Springs

The New York and Canada Railroad was a railway company that operated in the state of New York between 1873 and 1908. It was established to consolidate existing companies in the northern part of the state and to complete a north–south railway line along the west side of Lake Champlain. Through service to Plattsburgh, New York, began in 1875, and the company later extended further north to Rouses Point, New York (1876), and to the Canadian border (1906). Always under Delaware and Hudson Railway control, the company was formally merged in 1908. Today, the Lake Champlain line is part of the Canadian Pacific Kansas City's Canadian Subdivision.

History

The backers of the Whitehall and Plattsburgh Railroad had attempted to establish a railway line along the west side of Lake Champlain via the Ausable River valley.^[1] The effort sputtered out in 1870–1871, leaving two disconnected railway lines: a 21-mile (34 km) line between Plattsburgh, New York, and Ausable, New York, and a 15-mile (24 km) line between Port Henry, New York, and Fort Ticonderoga.^[2] The latter had been leased by the Rutland Railroad in an effort to prevent the creation of the new route.^[3]

This setback proved temporary. New York State Assemblyman Smith Mead Weed, and Rensselaer and Saratoga Railroad president Isaac V. Baker, persuaded the Delaware and Hudson Railway to back a new effort to build the line.^[4] The first New York and Canada Railroad was incorporated on March 16, 1872, and the consolidated with the Whitehall and Plattsburgh and Montreal and Plattsburgh Railroads on April 15, 1873, to form the second New York and Canada Railroad.^[5]

The New York and Canada eschewed the Ausable River route of the White and Plattsburgh in favor of a more direct route that followed the Lake Champlain coast. The company completed the 24-mile (39 km) line between Whitehall and Addison Junction on November 30, 1874.^[6] The difficult terrain between Port Henry and Plattsburgh required an additional year and that part of the line opened on November 29, 1875.^[7] The Whitehall and Plattsburgh Railroad line to Ausable was retained as a branch. To reach Montreal, trains used the former Montreal and Plattsburgh Railroad line between Plattsburgh and Mooers, New York, then the Ogdensburg and Lake Champlain Railroad from Mooers to Rouses Point, New York, and then the tracks of Grand Trunk Railway.^[8]

The New York and Canada constructed a 13-mile (21 km) line from Chazy, New York, to Rouses Point, eliminating the need to run via Mooers and the Ogdensburg and Lake Champlain Railroad. This line opened on September 18, 1876.^{[9][lower-alpha 1]} The New York and Canada also constructed a short, 5-mile (8.0 km) branch through Ticonderoga, New York, to Baldwin, on the north end of Lake George. This line opened in May 1875.^[10][12]

A final shortening of the route to Montreal occurred with the building of the Napierville Junction Railway and subsequent D&H control. The Napierville Junction Railway, incorporated in 1906, built a 27 miles (43 km) line from the Canadian border near Rouses Point north to Delson and a junction with the Canadian Pacific Railway. The New York and Canada built a 1.1 miles (1.8 km) connection up to the border. The new route opened on May 20, 1907.^{[lower-alpha 2]} The D&H merged the New York and Canada on May 23, 1908.^[12]

Lines

The main line of the New York and Canada Railroad ran from Whitehall, New York, to the Canadian border via Plattsburgh and Rouses Point. This line forms the major part of the Canadian Pacific Kansas City's Canadian Subdivision.^[16] In addition, the company had three branches:

• the Ausable Branch, the original line of the Whitehall and Plattsburgh south from Plattsburgh. It was abandoned in 1981.^[17]
• the Baldwin Branch, running 5 miles (8.0 km) from Montcalm Landing on the main line to Baldwin on Lake George. A short line built by the Ticonderoga Railroad branched off to serve Ticonderoga proper.
• the Mooers Branch, the original line of the Montreal and Plattsburgh from Plattsburgh to the Canadian border. Its importance lessened when the Rouses Point cutoff opened, and it was abandoned in 1925.^[11][18]

Notes

Footnotes

References

• Interstate Commerce Commission (1927). Interstate Commerce Commission Reports: Decisions of the Interstate Commerce Commission of the United States. Valuation reports. Vol. 116. United States: U.S. Government Printing Office.
• Poor's Manual of the Railroads of the United States. United States: H.V. & H.W. Poor. 1914.
• Roberts, Earl; Stremes, David, eds. (2023). Canadian Trackside Guide. Ottawa, Ontario: Bytown Railroad Society. ISSN 0829-3023.
• Shaughnessy, Jim (1997) [1982]. Delaware & Hudson. Syracuse, NY: Syracuse University Press. ISBN 0-8156-0455-6. OCLC 36008594.
• Waller, Altina (1994). "The Perils of Capitalism: Smith Weed and Entrepreneurship in Northern New York, 1864–1902". New York History. 75 (2): 173–208. JSTOR 23181825.