TNC
TNC connector on the left beside BNC.
Type RF coaxial connector
Production history
Designer Paul Neill and Carl Concelman
Designed Late 1950s
Manufacturer Various
General specifications
Diameter Male: 0.590 in (15.0 mm)
Female: 0.378 in (9.6 mm)
(outer, typical)
Thread 7/16-28 UNEF
Cable Coaxial
Passband Typically 0–11 GHz

The TNC connector (acronym of "Threaded Neill–Concelman") is a threaded version of the BNC connector.

Description

The interface specifications for the TNC and many other connectors are referenced in MIL-STD-348.[1] The connector has a 50 Ω impedance and operates best in the 011 GHz frequency spectrum. It has better performance than the BNC connector at microwave frequencies. Invented in the late 1950s and named after Paul Neill of Bell Labs and Carl Concelman of Amphenol, the TNC connector has been employed in a wide range of radio and wired applications.[2][3]


The TNC connector features a 7/16"-28 thread,[4] not to be confused with a 7/16 DIN connector, which is the diameter of the mating surfaces as specified in millimeters.

Variations

Reverse-polarity TNC

Left, a male RP-TNC connector from a 2.4GHz antenna. Right, a standard male TNC connector on a UHF antenna.

Reverse-polarity TNC (RP-TNC, sometimes RTNC) is a variation of the TNC specification which reverses the polarity of the interface. This is usually achieved by incorporating the female contacts normally found in jacks into the plug, and the male contacts normally found in plugs into the jack.[5]

Because they were not readily available, RP-TNC connectors have been widely used by Wi-Fi equipment manufacturers to comply with specific local regulations, such as those from the FCC,[6] which are designed to prevent consumers from connecting antennas which exhibit gain and therefore breach compliance. The FCC considered that the RP-TNC was acceptable in preventing consumers changing the antenna; but by 2000 it regarded them as readily available,[7] though delaying its ruling indefinitely.[8] As of 2013, leading manufacturers are still using RP-TNC connectors on their Wi-Fi equipment.[9] Plug on the female connector and receptacle on the male when dealing with RP-TNC.

TNCA

The TNCA connector is a variant of the TNC connector specified in MIL-STD-348[1] designed to provide an air gap in the dielectric region between the male and female connectors. The socket version of the TNCA connector is nearly identically to the standard TNC connector, while the pin contact version provides the air cavity differentiating it from a standard TNC connector, as such TNCA connectors are mechanically compatible and matable with standard conjugate TNC connectors.

75 ohm TNC

Most TNC connectors are 50-ohm type even when used with coaxial cable of other impedances, but a 75-ohm series is also available, providing a good SWR to about 1 GHz.[10] These can be recognized by a reduced amount of dielectric in the mating ends. They are intermatable with standard types.

See also

References

  1. 1 2 RADIO FREQUENCY CONNECTOR INTERFACES FOR MIL-DTL-3643, MIL-DTL-3650, MIL-DTL-3655, MIL-DTL-25516, MIL-PRF-31031, MIL-PRF-39012, MIL-PRF-49142, MIL-PRF-55339, MIL-DTL-83517 (B with change 3 ed.). US DOD. 2017-01-22.
  2. E-Base Interactive. "TNC Connector Series". Amphenol RF. Retrieved 2011-01-12.
  3. "Electronic Warfare and Radar Systems Engineering Handbook". Microwaves101.com. Naval Air Systems Command. April 1999. pp. 1.15, 6.32. Retrieved 16 January 2017.
  4. "TNC Connectors | Wellshow -RF Connector, RF Coaxial Cable Assembly, GSM, GPS, WiFi Antenna Manufacturer".
  5. "RP-TNC Connector".
  6. U.S. Code of Federal Regulations: 47 CFR 15.203, available at http://www.ecfr.gov
  7. FCC public notice, "OET clarifies antenna connector requirements for Part 15 Unlicensed Transmitters", http://hraunfoss.fcc.gov/edocs_public/attachmatch/DA-00-1087A1.pdf
  8. FCC public notice, "OET extends effective data of antenna connector requirement indefinitely" http://hraunfoss.fcc.gov/edocs_public/attachmatch/DA-00-2225A1.pdf
  9. Getting Started Guide: Cisco 3600 Series Access Points http://www.cisco.com/en/US/docs/wireless/access_point/3600/quick/guide/ap3600getstart.html#wp59090
  10. "HUBER+SUHNER TNC 75 Ohm series (EN)". Hubersuhner.com. 2010-10-28. Archived from the original on 2011-07-12. Retrieved 2011-01-12.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.